Kia Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I am installing an after market set of reversing bumpers sensors in a 2012 Kia Rio (Australian model) and I need to splice the power supply wire from the unit into the wire for the reversing light in the rear light cluster on one side of the car at the rear.

There is a 5 wire plug with the following wires going to the rear left light cluster:

- 2 x yellow
- 1 x black
- 1 x green
- 1 x red

I am not an auto-electrician and I am not sure which wire goes to the reversing light. If need be I'll cut (and reconnect) them one by one until I find which one powers the reversing light, but if somebody knows it'd be a great help!
 

·
Registered
Kia Rio YB . GT-line 2018
Joined
·
213 Posts
behind the left back withe car part where the safty belt is behind there is a big plug there you can take frome the green wire the backup power
in the photo there is my power probe in that exact spot
hope it is of help

 
1 - 2 of 2 Posts
Top