Kia Forum banner

1 - 4 of 4 Posts

·
Registered
2011 Kia Sorento 2.4L 2WD Base Model
Joined
·
2 Posts
Discussion Starter #1
I replaced the VCM and shortly afterward the coupling broke, now engine light is on. Opened VCM and it runs fine, just want light off. Anyone know where I can purchase just the coupling?
 

·
Registered
2011 Forte SX 2.4L (thankfully MPI) A/T 144K miles
Joined
·
1,594 Posts
Are you referring to the piece inside of the intake manifold that the VCM slides into and interfaces with?
 

·
Registered
2011 Kia Sorento 2.4L 2WD Base Model
Joined
·
2 Posts
Discussion Starter #3
Are you referring to the piece inside of the intake manifold that the VCM slides into and interfaces with?
It's the small piece that connects VCM to to the manifold "flap" about 3/4 in diameter and 3/4 in long
 

·
Registered
2011 Forte SX 2.4L (thankfully MPI) A/T 144K miles
Joined
·
1,594 Posts
I wasn't understanding what you were referring to, because the VCM consists of only one part on my Forte. So I took a look at the parts diagram for your vehicle, and it was very obvious that your VCM system is quite a bit different than mine. Without actually being able to see it first hand, I can't tell what you're looking at, but here's the diagram for you to check. Perhaps one of the VCM parts listed in there will help you ID what you're looking for.

 
1 - 4 of 4 Posts
Top