Kia Forum banner
1 - 2 of 2 Posts

·
Registered
2011 Sportage SX
Joined
·
978 Posts
There are some instructions available on KIATechInfo that you'd have to piece together from different sections. Basically you'll have to remove rear part of the headliner to be able to get to the connectors and the nut that holds the base of the antenna. Disconnect the quick connectors from the power cable and the antenna feeder cable. Once both are disconnected, just remove the nut that holds the base to the vehicle and you're done. Installation is just the opposite.
 

·
Registered
2011 Sportage SX
Joined
·
978 Posts
Hehehe, I had vinyl applied to that roof panel too! The installer was able to pull down enough of the weatherseal on the hatch to pull down just enough of the headliner to reach the connectors and the base. I think he just loosened the retaining nut just enough to run the vinyl underneath the antenna base...I was in their waiting room enjoying their free wi-fi.
 
1 - 2 of 2 Posts
Top