Kia Forum banner

1 - 4 of 4 Posts

Registered
kia borrego V8 EX limited 2009
Joined
6 Posts
Discussion Starter #1
HI EVERY BODY , my kia borrego 2009 V8 EX have problem with the mass air flow sensor connector (5 pin).
how to make the connector wiring ? what color in the pin 1, 2,3,4,5 ?


please someone could help me to make my MAF work well ?

:(::crying::
 

Registered
kia borrego V8 EX limited 2009
Joined
6 Posts
Discussion Starter #2
Please help me,馃槬 need to if this wiring is good before connect him to the MAF . if not guide me with the correct wiring
 

Attachments

Registered
Borrego 2009
Joined
74 Posts
Borrego is not good at providing electrical schematic drawings at the wire color level but here is the schematic. Note that the power is on circuit two but the schematic connector drawing shows it in the #1 position but the connector layout shows it in the #2 position. My guess is that the schematic is for drawing convenience.

 

Registered
kia borrego V8 EX limited 2009
Joined
6 Posts
Discussion Starter #4
thank you a lot, i'm gonna try to make it work with your diagram :D
 
1 - 4 of 4 Posts
Top