[sfcwtu]

That's great! Cheers!

 

[sfcwtu]

Thanks sfcwtu. The PSD Module I am referring to is p/n: 95450-4D103. Most the online listings I saw for it (ebay) said that dealer programming may be required. Of course when I called the dealer, they insisted programming is required and strongly recommended I buy the part from them to avoid throwing my money away. Can I ask, how did you purchase your replacement? I just bought a new module from the dealer since I decided a used one might be risky. I am going to install it once it arrives and my fingers are crossed that it will just work.

I bought a used part from an online junkyard provider for part#834854D101, the PSD drive unit which came with the control module you referred to (95450-4D103). I replaced the old one with the new one. I followed the reset procedure outlined in this article:
https://www.bodyshopbusiness.com/tech-tips-replacing-the-hyundai-power-sliding-door-control-module/ . Maybe that's what the dealer meant by programming. Hope it helps.

 

[sfcwtu]

Bump...

Has anyone ever replaced a PSD control module? I can't be the first person that had one go bad. I would really like to know if I truly need the dealership to program it to my car. The dealer is saying its $132 to program the new one. They are also threatening me about using parts acquired from outside their dealership. So I could end up having to pay them a programming fee even if they can't program the PSD module I supply. Wondering if buying the part used is a better or worse idea? Maybe it would already be programmed, but it could also be defective.

-Bill

Bill, I have replaced both a PSD control module (the one inside the sliding door panel where the actuator is located) and a PSD drive unit (the one inside the rear side panel above the wheel). Neither needed programming. Relacing the PSD drive unit will require a learning procedure, which can be easily done. It would help if you could provide the part number for the control module you are referring to.

 

[sfcwtu]

With the power mode enabled, did you hear any sound at all when press the button or pull the door handle? I am not talking about the beep sound, but the sound when the control assembly or drive unit is engaged. Also, is the floor light at the bottom of the center pillar on?

 

[sfcwtu]

I would begin with replacing the acturator. Read this thread carefully https://www.kia-forums.com/kia-carn....com/kia-carnival-sedona-2006/81215-please-help-power-sliding-doors-2007-a.html . It has youtube videos that show step-by-step instructions.