Last year we took most of the engine apart and attempted to do a valve job on it. Had problems so let it sit over a year. We decided to pull that engine out and replace it with a another 2.7L from a 2007 Kia Sportage.
I am struggling to find detailed information about where each section & connectors of the wire harness go to and connect to.
I took some pictures and a video- I thinks that I have found the strand that goes to the back and connects to the alternator among other things though I am not sure where the brackets go. Does the strand that goes to the bottom back ( alternator , etc.) go underneath the other strands and connectors that I have already connected? I'm trying to figure out where to route the strands. Feel free to let me know which connectors are in the pictures if you know. Thanks
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
I am struggling to find detailed information about where each section & connectors of the wire harness go to and connect to.
I took some pictures and a video- I thinks that I have found the strand that goes to the back and connects to the alternator among other things though I am not sure where the brackets go. Does the strand that goes to the bottom back ( alternator , etc.) go underneath the other strands and connectors that I have already connected? I'm trying to figure out where to route the strands. Feel free to let me know which connectors are in the pictures if you know. Thanks
