Kia Forum banner

1 - 3 of 3 Posts

·
Registered
Kia Sportage A/T 4WD 1997
Joined
·
91 Posts
Discussion Starter #1
Recently I got my hand on some cheap lock hub and they cost only about 30 USD. The problem is I need to know the specification for the front shaft.

Can anybody please do me a flavour to have a look as I already sold my too problematic Sportage and still eyeing for one with good condition. I need to know the diameter of the shaft, how many splines on it, and what's the PCD of the hub.

The 26 splines one say it fits the Sportage, but I remember I read somewhere it says that some newer model (97 onward if not mistaken) is running 28 splines. Any idea?
 

·
Premium Member
96 4 DOOR 4WD SPORTAGE, 2014 Hyundai Elantra GT, 2015 Accent Hatchback Sport
Joined
·
651 Posts
First generation sportages all share the same front 26 spline axle shafts.
It's the rear that change on the 98 and up. They go from 26 to 28 spline.
If you decide to sell them, I would be interested in trying them out and see how they compare to Warn.
UPYOURKIA
 

·
Registered
Kia Sportage A/T 4WD 1997
Joined
·
91 Posts
Discussion Starter #3
First generation sportages all share the same front 26 spline axle shafts.
It's the rear that change on the 98 and up. They go from 26 to 28 spline.
If you decide to sell them, I would be interested in trying them out and see how they compare to Warn.
UPYOURKIA
So the front is actually all same then it's not a problem.
Yes I'm currently selling them at 30 USD without shipping.

Do you mind to measure how much is the PCD of the hub bolt?
Just to make sure it really fits.
 
1 - 3 of 3 Posts
Top