Kia Forum banner

Less than one month ownership and my first BONEHEAD move

3366 Views 7 Replies 6 Participants Last post by  accelerus
So - I had to make a night run for some energy drink and gas after a long drive back home from Houston.

Almost into my 4th week of ownership with my Kia Rio - and as it happens this is the first time I have a car port.

Pulled into my spot and if I park with the front of the car facing into the space there is a large solid steel beam supporting the carport structure at my apartment complex. Open my door, and get ready to get out, and holy crap the steel beam is moving! Straight towards my open door.

I panicked and started stabbing for the brake pedal but since it's dark and im twisted sideways in my seat all I was hitting was the clutch. I Hear the crunch and just die a little inside.

move the car back up - the door was forced open about an extra foot past it's "Maximum travel".

*sigh* No visible outside damage just have to push a bit more to close the door. I'm thinking the worst and then I go in for a closer inspection and see this:

After looking at what happened -- even though this SUCKS, this car is engineered WELL. So even after hyper extending the door and making a terrible breaking noise - all that snapped was this little stablizer bar that's mounted in the door itself. Doesn't look like it would cost that much to buy the part, funny enough I have to take the door apart ANYWAY to install some speakers so this should be an easy fix.

The only reason the door is hard to close is because the broken ring piece on the left hand side is bent out and you can see where it's scratched the inside door frame a bit from when trying to close (some slight pressure pushes the door in enough to lock and seal)

After thinking the worst -- I'm very surprised. no external damage, no bent body parts, just a snapped connector door rod.

Funny enough I USUALLY always back into my parking space but was feeling lazy tonight. I'm still getting used to this parking area and realized that it has an ever so slight incline towards the street (hence why i started rolling in the first place)

Be safe and careful guys -- I know this would be MUCH worse had I not found the brake at the last second.
See less See more
1 - 1 of 8 Posts
Ouch!! Yeah depending on how the door module is designed. It shouldn't be terrible to replace the checker. You may have to remove the window glass in order to get the door module far enough out to replace the checker. With certain models you'd have to disassemble the entire door. Hopefully the RIO isn't one of them.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.