Kia Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
I've got a kia optima 2004 2.4 replaced timing belt, crankshaft sensor, water pump and alternator car starts but oil light comes on at slow RPMs plus when I put the a/c power steering belt on car won't start When the car ran no vibrations but smelled like eggs after it warmed up. Car has been sitting for about 1 year finally got around to working on it . Need to get it running just cant figure out why by putting a/c power steering belt on causes hard turnover. I know belt was not too tight as soon as the belt is put on it wont start. power steering and a/c pullies spin fine. I'm planning on changing camshaft position sensor. Just not sure if that's going to help
 

·
Registered
Joined
·
2 Posts
Discussion Starter #2
2004 Kia timing belt replacment

After replacing the timing belt crankshat sensor camshat sensor plugs and wires I got the car running runs with no ticking, smoke or oil light for about five minutes thenn it starts ticking from the lowernpart of the engine and the oil light flickers aat low itel does anybody have any ides as to what else it can be ?
 
1 - 2 of 2 Posts
Top