Kia Forum banner

1 - 3 of 3 Posts

·
Registered
2012 Sorento 2.4L EX
Joined
·
1 Posts
Discussion Starter #1
Hello,

Does anyone know how to get the power wire for an aftermarket amplifier past the firewall through an existing grommet. Or no a safe place to drill a small accessory point? Any assistance is greatly appreciated.
 

·
Registered
Silver 2012 Kia Sorento FWD Base with 2.4L
Joined
·
123 Posts
Unsure if it's the same for Kia but in this video of a another different vehicle, a coring tool is used. Start at 1:40 to see what I mean.
 

·
Registered
2011 Sorento I4 Manual
Joined
·
9 Posts
Hello,

Does anyone know how to get the power wire for an aftermarket amplifier past the firewall through an existing grommet. Or no a safe place to drill a small accessory point? Any assistance is greatly appreciated.

Hey dude I feel your pain I did this a month ago. I've got the manual version. I went through the rubber where my shift cables come through. I used a 90 degree drill adapter and a step up drill bit. Basically burnt a hole through it from the inside out. Taped a zip tie to my 4 guage and lubed it up.. When I was done I brake leaned the lube off and then put a healthy a mount of silicone on it.
 
1 - 3 of 3 Posts
Top