Kia Forum banner

DIY large cup holder mod

13K views 8 replies 6 participants last post by  AzSX 
#1 ·
here is a DIY mod for your large cup holder in sportage 2012 ... semi dense foam and carpet mesh double sided tape.
 

Attachments

See less See more
1
#3 ·
I feel ya. They are HUGE. Better than being too small, but still annoying sometimes since most cups have a "sloppy fit" when in the holder. I always make sure to take a few sips of whatever I have before leaving :rolleyes:

I wish they had an oem or aftermarket insert or something to make it a bit more snug. That way you could remove it as needed for "super sized" cups etc...
 
#8 ·
My cupholders have a small "step" at the bottom (unlike the ones pictured in post #1). The inserts and the ashtray will fit the smaller bottom but he larger opening leaves about a 1/4" gap all around the opening. I wrapped some black foam weatherstripping around the ashtray or insert to prevent stuff from falling into the gap and to keep it steady.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top