Kia Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Ok I did a integration to add a external sub amp I tied into the sub output and disconnected the sub well my best guess is the ohm load was to low with out the sub on it and I now have a fried surface mount transistor I want to know if there is any way to integrate onto the input of the amp to now run a four channel amp ... The factory amp is just over 700 bucks so open to any ideas thanks ,, p.s. I want to retain the uvo
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top