Kia Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Okay, so I have a Chilton manual for my beast of a car and I'm attempting to clean my MAF sensor, but for the life of me, I can't figure out how to disconnect the electrical connector on the front side of the MAF housing. The picture in the manual is completely useless. A picture of it removed would help. Or something.
 

·
Super Moderator
2008 SpectraSX, 2014 Optima LX,2006 Jeep Liberty, Linux Mint Mate
Joined
·
6,962 Posts
First... You DON'T touch the MAF as it is very fragile so removing it is a no no..
There are spray MAF cleaners for this job.. It should be located in the large rubber air hose. Disconnect both ends spray the sensor, let dry, reconnect...
Dave
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top