Kia Forum banner

Recent content by KevoDafro

  1. 99 shuma idle problems

    Kia Cerato, Shuma & Spectra Forum
    I should first ask what motor you have in the '99 Shuma' Here is the states there is no 99 shuma, only a Sephia with the 1.8L. You need to make sure there is a tube going between the Throttle Body and the Maf sensor. The IACV and TBS are located right on the Throttle Body itself. If the TPS...
  2. 2001 KIA Spectra GS Problems

    Kia Cerato, Shuma & Spectra Forum
    It usually takes 1 warm-up for the CEL to come on. That is why it took so long for it to appear. You can run without the maf, and your gas mileage will not be effected by that much. I can still get 32mpg with no maf or 2nd O2 hooked up. It is amazing you are only getting 8-10 miles a gallon (we...
  3. http://www.revolutionautoworks.net

    Cerato (2003 - 2008) & Spectra5 (2004)
    ...and holy off topic batman. anyway I made my point. only a few weeks left before the track closes anyway. Yeah i have no idea what the entire A/C assembley weighs. Never had it to weigh along with other options so those thing were not counted. oh, and for those that use the 100lbs. = 1/10th...
  4. http://www.revolutionautoworks.net

    Cerato (2003 - 2008) & Spectra5 (2004)
    The point I was making about the "hp calculator" thing was that IF the trap speed did not change only the weight and 1/4mile time, then the difference was only a few HP. Examples I ran: 1/4 mile time: 14.9 Trap Speed: 97 Weight of vehicle with driver (pounds): 2540 [email protected] 1/4 mile time...
  5. http://www.revolutionautoworks.net

    Cerato (2003 - 2008) & Spectra5 (2004)
    I never mentioned you claimed anything or even know where you got that from, so possible miscommunication there. 1st, a manual spectra runs 16.3-16.5 stock. The autos run low to mid 17s stock.A good driver can run quicker, and there have been others that have posted breaking into 15s with...
  6. http://www.revolutionautoworks.net

    Cerato (2003 - 2008) & Spectra5 (2004)
  7. http://www.revolutionautoworks.net

    Cerato (2003 - 2008) & Spectra5 (2004)
    well I am referring to my car and to hit mid 14s you do not need 200hp, no way. My car does way around 2500 with driver. I do not hit 4th by the end of the quarter either. Rev limit is set to 7300rpms. 3rd gear redlines at 99-100mph. Also, to help illustrate the point, a year ago I used a...
  8. 2003 Spectra Wiring Diagram

    Shuma & Spectra (1997-2003)
    Be sure to check ALL your grounds. the engine needs to be grounded is several places. I did the same thing when I re-qired the whole car. I did not tight the engine grounds because I was just testing and planned to add a few more grounds to the same spot. The starter would not crank at all...
  9. belt tensioner pully help!

    Shuma & Spectra (1997-2003)
    The outer belt uses the Power Steering pulley to apply tension. There should be a long tension bolt on the bracket and another perpendicular bolt that locks it from sliding once you get the proper tension. It should be pretty obvious once you see it. I have a picture from underneath that I will...
  10. http://www.revolutionautoworks.net

    Cerato (2003 - 2008) & Spectra5 (2004)
    I no longer have the dyno sheet. This product was designed about 3 years ago for both generations. The physics alone justifies the ideal setup. On a stock motor the gains from one true CAI to another will only be a few hp, if that. But as you add the mods the more difference it will make. I have...
  11. http://www.revolutionautoworks.net

    Cerato (2003 - 2008) & Spectra5 (2004)
    Actually its not.. Our intake has less bends and shorter overall length then the competion. This gives maximum velocity. Our intake out performs the competion in all categories, from price, quality and performance. We use true S.S> T-bolt clamps, 3-ply silicone couplers and an optional Fujita...
  12. Revolution Autoworks, Our site is up!

    Parts For Sale / Trade
    thank you.
  13. Revolution Autoworks, Our site is up!

    Parts For Sale / Trade
    Finally have the official site up. CC software is beeing updated this week. Please Check it out. Also, I am always looking to expand our gauge face applications. We have a few more parts in the works as well. Revolution Autoworks, Inc. - Drivin' by the need to perform!
  14. 7500 rev limiy video, around the block.

    Image and Video Gallery
    lol a few...and an on-ramp lol
  15. 7500 rev limiy video, around the block.

    Image and Video Gallery
    taking the car for a drive. still needs a tune badly. Video - 7500rev limit. a drive around the block, un-tuned in the kia.
Top