2006 Sedona Hatch trim removal

[Billsboy]

I want to install a backup camera and need to run a wire from the license plate to one of the backup lights to pick up the 12 volt power for the wireless camera. Where can I find instructions for removal of the necessary trim?

Thanks, Bill

[Billsboy]

I think I found out how to remove the trim at:
http://www.kiatechinfo.com/
It seems to have the shop manual online.

[Geoff1965]

Remove the upper trim around the window first. Slide a ruler under and lever away carefully until the pop clips release. This will expose two screws that secures the top of the lower trim. Good luck. I did a similar job about 3 months ago.

[PeteB_2000]

just remove the rear light cluster and cut into the reverse light circuit so that when you engage reverse it powers on your camera, thats what I did when I fitted some reversing sensors